What Actually Happens During a Session
Every fitting follows the same four stages, whether you're booking a single wedge or a full bag rebuild ahead of a mountain trip.
Baseline Capture
We start by hitting your current clubs on the launch bay at Frisco field elevation, so we have a real measurement of your existing carry, spin, and dispersion — not an assumption. This step alone often explains misses a golfer has been fighting for years.
Condition Modeling
Next we build a working density-altitude model for your bag — your home course conditions across the seasons, plus any mountain trips or out-of-state rounds already on your calendar. This model drives every recommendation that follows.
Live Demo Testing
Using your baseline and condition model as the reference point, we work through heads and shafts from our demo wall, watching how each combination responds to your specific swing rather than a generic profile. Every swing is logged and compared side by side.
Build & Bench Check
Clubs are assembled on-site, then verified against target frequency and swing weight on our build bench before pickup. Most orders are ready within a week.
What We're Actually Measuring
Our launch bay captures clubhead speed, launch angle, spin rate, ball speed, carry, and dispersion on every single swing. Paired with real-time temperature and humidity readings, that raw data becomes a condition-adjusted spec rather than a sea-level guess.
Every Number Gets Localized
Raw carry distance off the launch monitor gets modeled against real Frisco air density — and, if it applies to you, against your next mountain destination too — before it goes on your spec sheet. That matters most on longer clubs, where a few thousand feet of density altitude can be the difference between the correct loft and a full club too much.
See the Process in Person
Book a session and walk through all four stages with your own numbers on the screen.